
Bored piers
Once the holes are dug, before the concrete pour
Pier alignment against the drawing, base soil compaction, diameter and depth, steel cage and concrete cover
Learn more about the bored piers inspection →Seven visits through a Greenbank build, each timed before the next trade hides the work.
One of our inspectors will call you back.
If it is urgent, email [email protected]
Fully licensed & accredited
Queensland Building & Construction Commission
Australian Society of Building Consultants
Strata Community Association
Building Dispute Practitioners Society On Greenbank slabs we keep recording the same three things: concrete too wet for the mix, steel cover less than the standard, and reinforcement not tied to the chairs. Frames bring a different list: a lintel height that misses the brickwork drawing, a stud gap too wide for a wall plate, and a timber post sitting on a concrete slab without a damp course. Then lock-up adds the services, with drainage pipes on the wrong side of the stormwater line. We assess the condition of exposed elements before they are covered up.

Once the holes are dug, before the concrete pour
Pier alignment against the drawing, base soil compaction, diameter and depth, steel cage and concrete cover
Learn more about the bored piers inspection →
Before the concrete arrives, once the mesh is laid
Edge cover, mesh level, step reinforcement, bars to wide beams, trimmers at openings, vapour barrier sealed
Learn more about the slab pre-pour inspection →
Frame and trusses standing, roof sheeted, before linings
Steel beam and column connections, joist hangers, double beams, tie downs, strap bracing, waste points, bottom plate bearing
Learn more about the frame inspection →
Cladding, windows and rough-in complete, before plaster
Cable clearances, gas and water pipe separation, pipes off steel framing, ducts suspended, head flashings, box gutter size and fall, sarking tears
Learn more about the lock-up (pre-plaster) inspection →
Joinery, doors and trims are checked before painting begins.
Balcony drains are sized correctly and connected, while control joints have no render on them.
Learn more about the fixing inspection →
Membrane inspection before tile work
Pinholes in the waterproofing, puddle flanges at correct heights, and upturned sheeting at junctions, specifically around the laundry floor drain.
Learn more about the waterproofing inspection →
Book a final inspection before handover
Facings and joints, balcony drainage and tile laying, window restrictors, water stops, capping falls, and ground clearances.
Learn more about the pre-handover (PCI) inspection →One finding from each stage, recorded on homes being built in Greenbank.
Bored piers
Slab
Frame
Lock-up
Fixing
Waterproofing
Handover

22 October 2026 · 3 min read
Builders must meet the guide when fixing work, but not all defects are a breach.

3 October 2026 · 3 min read
A pre-purchase inspection finds the major defects a standard building inspection can miss.

14 September 2026 · 3 min read
The Greenbank real estate market shows high values and steady growth for home buyers.
Building and Pest Inspections Building and pest inspections for Greenbank homes.
Pre-Handover (PCI) Inspections A full defect report for your new Greenbank build, ready before the handover.
Defect Investigation Reports Assessors look closely at the site and compare findings with approved plans and standards.
Pre-Purchase Building Inspections A visual AS 4349.1 inspection for established Greenbank homes.
Dilapidation Reports Check the foundation works before the builder pours concrete.
QCAT Expert Witness Reports Tribunal-ready expert reports for disputes at QCAT.
Pre-Sale Inspections Find defects before the handover inspection and avoid paying for repairs later.
Apartment and Strata Inspections Your new home and the landscaping you can see around the house. Instant online pricing for Greenbank, or contact the booking team.
Stage inspections during a build are crucial. They check the approved drawings and engineering. These findings determine the structural integrity of the home.
If a concrete slab sits uneven, engineers usually specify additional steel reinforcement around the low spot. We have recorded them missing on Greenbank pours, which the engineer then has to review.
Standard residential contracts allow you to engage your own consultant. We schedule the inspection to fit around your builders.